User Tools

Site Tools


mvp_1.0_build_lights

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
mvp_1.0_build_lights [2017/07/01 19:40]
webbhm
mvp_1.0_build_lights [2017/07/01 23:48] (current)
webbhm
Line 9: Line 9:
   - Measure 8 inches in from each corner, and mark this location. ​ This is where the lamps will eventually hang.   - Measure 8 inches in from each corner, and mark this location. ​ This is where the lamps will eventually hang.
   - Measure back (toward the corner) from each mark, and draw a 2 inch box.   - Measure back (toward the corner) from each mark, and draw a 2 inch box.
 +{{:​img_20170630_151245.jpg?​200|}}
   - On just the outside layer of cardboard, cut out these four squares, and cut a slit along the diagonal, from the square to the mark.   - On just the outside layer of cardboard, cut out these four squares, and cut a slit along the diagonal, from the square to the mark.
-  - On the inside layer.+  - On the inside layer, a 1/2 inch back from the mark (1/4 inch in from the top square, draw a 1 inch square. 
 +  - You will now cut a squared off "​Y"​ shape, or something that looks like an American football goal post.  The base is the line from the mark to the square. ​ This is where the electrical cord will be located. ​ The arms of the "​Y"​ will form a flap through which you can insert the plug of the lamp fixture. 
 +{{:​img_20170630_152429.jpg?​200|}} 
 +  - Insert the plug through the flap, pulling it all the way through till the bulb holder is next to the top of the box. 
 +{{:​img_20170630_152754.jpg?​200|}} 
 +  - Close the flap, and put a piece of duct tape over the flap to keep it closed. 
 +  - Repeat this for all four marks. 
 +{{:​img_20170630_153226.jpg?​200|}}
  
mvp_1.0_build_lights.txt · Last modified: 2017/07/01 23:48 by webbhm